|
Atlas Master Series GP38
 |
Atlas Master Series EMD GP38 |
Easiest decoder install yet - comes built-in!
Just remove the dynamic brake section on
the top of the engine to expose the decoder. The engine
is delivered set for analog (conventional DC) operation.
Move the jumper plug over to configure for DCC
operation. The decoder's address is factory
preconfigured to the last two digits of the engine's
number (undecorated or unnumbered units are set to
address 03).
Atlas
340-series Dual-Mode Decoder
- 14/28/128 speed steps, extended addressing,
advanced consisting
- 1.0 amps
- Two functions (each rated 200ma), Special
lighting effects
- Operation mode and RP-9.2.3 programming
- Atlas circuit board form factor,
2.88"x0.68"x0.26"
 Any of the other Atlas lightboard form
factor decoders would also fit as a replacement in this
engine. Click on photo at right for more information on
these decoders.
Photos by Richard Schumacher
|
|
